Hi,
Is there anyway to restrict the user from viewing the top view of virtual tours?
Thanks
No top view?
What do you mean with "top view"? Limiting the tilt angle? If so: Yes, you can change those values in the "Viewing Parameter" box on the settings tab.
MfG, Thomas
- 360Texas
- Moderator
- Posts: 3684
- Joined: Sat Sep 09, 2006 6:06 pm
- Location: Fort Worth, Texas USA
- Contact:
Return to the Viewing parameters click check mark middle of the panel "View viewing parameters".
now you should see angle of view values on all 4 sides to the image. In particular locate the values in the top and bottom boxes. The should read 90 and -90.
+90 degrees from center 0 to image top
Consider 0 to be mid center on the horizon.
-90 from mid center 0 to the image bottom.
So you do not want see the top area.. then reduce the +90 upper viewing limit to only see up to say +70 degrees above the horizon. Same for the lower area
now you should see angle of view values on all 4 sides to the image. In particular locate the values in the top and bottom boxes. The should read 90 and -90.
+90 degrees from center 0 to image top
Consider 0 to be mid center on the horizon.
-90 from mid center 0 to the image bottom.
So you do not want see the top area.. then reduce the +90 upper viewing limit to only see up to say +70 degrees above the horizon. Same for the lower area