I was wondering if someone could help me. I presume we are able to zoom in (move/rotate) from one location to another when transitioning from node to node. Under viewing parameters I set the fly in location (the start) using the center marker. From there I select the end point where the transition should end in the next node, using default view. I have done that for every node. When I click generate output it does the transition correctly on load. But when I select the next node it does not perform my expected behavior. The same is repeated for the other behavior.
I made a video of this. Thanks in advance.
https://youtu.be/JHDmvHz8Fa0
Leon Herbert
Fly in to default view.
-
- Posts: 7
- Joined: Mon Feb 05, 2018 1:52 pm
- Contact:
Leon Herbert
Three Sixty Pro
Three Sixty Pro
- Hopki
- Gnome
- Posts: 13025
- Joined: Thu Jan 10, 2008 3:16 pm
- Location: Layer de la Haye, Essex UK
- Contact:
Hi Leon,
Under transition you need to select After: Fly In.
Regards,
Hopki
Under transition you need to select After: Fly In.
Regards,
Hopki
Garden Gnome Support
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
If you send an e-mail to support please send a link to the forum post for reference.
support@ggnome.com
https://ggnome.com/wiki/documentation/
-
- Posts: 7
- Joined: Mon Feb 05, 2018 1:52 pm
- Contact:
Thanks Hopki!
Leon Herbert
Three Sixty Pro
Three Sixty Pro