Thank you, Hopki, for your input!
I tested the ggsk you sent with the following result:
http://www.pano.szenerien.de/Panorama-P ... ation.html
I'm afraid this is not the solution for this navigation-task.
Can you please have a look at your settings in your ggsk?
Best regards
Harald
-----------------------------------
I realized that you wrote "Air" in the button ID and "air" in the value of the logic block and renamed the button ID in "... air".
Now there is only one function left which is missing:
Open the tour, rotate panorama 1 and click on the button. The panoramas 1 and 2 should always be at the same position to have this blending effect.
With your ggsk, the second panorama openes always at the starting position.
---------------------------------------------------------------------------------------------------
Requirements:
1. Only one button on screen at the same time
2. 2 Buttons only:
a) Go to panorama during the event (aerial-pano 2)
b) Go to panorama before the event (aerial-pano 1)
3. First node is aerial-pano 1, second node is aerial-pano 2
4. Third and the following nodes are ground-panoramas
5. Panoramatour begins with aerial-pano 1 and button 2a (Go to panorama during the event)
6. Click on button blends aerial-pano 1 with aerial-pano 2
and hides button 2a, button 2b appears (Go to panorama before the event)
7. The directions of the two panoramas have been adjusted by setting north
8. After rotating aerial-pano 2 and clicking button 2b, aerial-pano 1 appears at the same position as the last direction of
aerial-pano 2
9. In aerial-pano 2 many hotspots to the ground panoramas appear.
10. Clicking on a hotspot openes a ground-panorama with a pre-defined orientation.
11. In all these ground-panoramas button 2a appears. (Go to panorama during the event)
12. Click on this button always leads to aerial-pano 2 with the hotspots.
13. In order to prevent an unsuitable starting orientation of aerial-pano 2 like sky or parking lot, button 2a should open the panorama always in the starting orientation from where the user can choose other hotspots.
14. Button 2a (or a third button which looks the same as button 2a) must execute different actions.
I hope, there can be a way to acheive this. I have tried again and again with no success.