Made some progress - then got confused again.
So here is progress report:
Issue:
Pano1 = Skin shows properly lower left corner of stage. Click on Pano2, 3 and 4 thumbnail goes properly to HTML (s) but skin has vanished.
Created a new OUTPUT Flash and HTML5 configuration"
Flash and HTML 5 will use the same Skin named "360texasthumbar"
Flash typical settings. Skin Editor shows
Container named "thumbar" inside are children:
4 100x100 thumbnails
+1 <- -> button graphic
The thumbar slider performs Left and Right sliding off /on stage correctly
---
All 4 thumbs are configured:
ID: separate ID for thumb 1,2,3 and 4
POS x/y Anchored upper left
Scaling 1 & 1 no scaling
Angle 0,0
Visible [x] Alpha 1
States: no state specified
Format [x] .png
Quality - grayed out
Hotspot proxy ID none required because 4 hotspots are on the static toolbar not on panorama
Actions/Modifiers
Mouse Click | Goto URL | URL= albrightpat.html Target: $self
Yes I have replaced Goto URL with Next Panorama and specified .swf but still loose the skin on pano's 2,3 and 4. Have replaced Target:$self with blank. No change
--
Behavior comments
On initial panorama 1 - Skin is off screen to left- only <-> button is showing.
Click <-> and thumbar extends to right on to the stage.
Click on #2 thumbnail and a new page is opened and pano is displayed - with no skin.
Alternate: I removed the Target $self and left it blank
Pano2 opens over top of previous Pano1 still no skin.
Observation
The HTML5/CSS output for iPhone/iPad2 are configured for cube face dimensions 1300 1024 960 width image sets. I ran it a several times.
Noticed that the cube face image set for 1300px gets duplicated and added to the original CF tile set. Now have 3 or 4 sets of 1300 pixel width in the IMAGE folder.
The original cube face tiles for 1024 and 960 sets remain unchanged.. like might be overwritten with each pass.
Here is a photoshop picture of both pano1 and pano2 showing the skin missing in #2
I would appreciate questions and constructive comments.