Garden Gnome Software

Hello everyone
I have the one panorama for multiple rooms, and i wanted for each room to have a point on map.
Sure, i can copy the panorama with similar name and put it in project with new location on map, but this will be not optimized for downloading speed of the tour.
Is there is workaround of it?

Hi veryetti,
Understand what you are asking but using the Map element you can not do this as a map pin will represent an actual node.
Have a look at this project, it uses the same tiles for different nodes: viewtopic.php?p=62842#p62842
Regards,

Your example shows a floor plan, not a map.

A single node can be on multiple floorplans, as there can always be areas on multiple floors, like the staircase or an atrium. Just drag the node on each floor plan. No special treatment is needed.

If you have automatic floor plan switching in the skin, the "closest" floor plan is chosen, where the node is available.